The drum bearing supports the rear of the dryer drum. Over time, the drum bearing wears out. If the drum bearing is worn out, the dryer may make noise. To determine if the drum bearing is at fault, remove the dryer belt and try turning the drum by hand. If the drum rotates freely, it is unlikely that the drum bearing is worn out.

In some models of gas or electric clothes dryers, the drum is supported at the back of the cabinet by a bearing. Depending on the model of dryer, the bearing may be a ball and socket bearing, or a shaft connected to a sleeve bushing. A defective or broken rear bearing will make squealing or squeaking noises, and will have to be replaced.

The o-ring seals the drum bearing to the drum. It is normal for the heat of the dryer to cause o-rings to warp over time. If the dryer is making noises while in operation, the drum bearing o-ring may be worn and need to be replaced. To start, disconnect the dryer's electricity and pull the machine out from the wall to make it easier to work with.

The noise will get louder if the bearing is not replaced.A screwdriver, putty knife, and socket set are required to make this repair. To start, disconnect the power from the washing machine. Take the top off of the machine and remove the screws from the front panel to take it off.

Feb 15, 2020 Dryer Knocking or Rattling. When a Maytag dryer making noise sounds like rattling or knocking, there can be several causes with straightforward fixes: Loose items: make sure all zippers, buckles and buttons are fastened before placing clothing in dryer. Empty pockets of any small items. Items near or on top of the dryer: remove any objects that ...

Drum Bearing is Damaged. This metal bearing on the rear of the dryer drum helps support the drum and enables it to rotate smoothly. It can wear with time, and when it does, you’ll hear your Frigidaire dryer making grinding noise as the drum bumps the dryer panel. To verify that the drum bearing is causing the noise, remove the dryer belt and ...

The drum bearing supports the rear of the dryer drum. Over time, the drum bearing wears out. If the drum bearing is worn out, the dryer may make noise. To determine if the drum bearing is at fault, remove the dryer belt and try turning the drum by hand. If the drum rotates freely, it is unlikely that the drum bearing is worn out.

Otherwise, the noise is from the contents of the dryer, and service is not required. This is caused by either of the following: The dryer is overloaded. The sound is the load thumping against the side of the dryer as the drum rotates. You should turn items with large or oversized buttons, snaps, or zippers inside out to reduce this sound.

Louder noises at the top of the dryer suggest a drive belt problem, while noises from the rear suggest drum bearing issues, and noises close to the floor point towards idler pulley or motor issues. Drive belt: A worn, cracked, or stretched belt that fails to grip the dryer drum properly will result in a squeaky noise on each full rotation.